How to Use a Lishi 2-in-1 Pick & Decoder

Every Lishi 2-in-1 works the same way. Once you understand the four parts and the four steps below, you can apply the same technique to any keyway — from a Schlage SC1 deadbolt to a HU101 Ford ignition.

Parts of the Lishi 2-in-1 tool and the four usage steps

1. Know the four parts

  • Pick body — the blade at the front. It goes fully into the keyway, all the way until it seats on the pins. If it is not fully inserted, every reading you take will be wrong.
  • Tension lever — the wide lever underneath. It holds light turning pressure in the direction the lock opens.
  • Lifter — the thin lever at the back. It lifts one pin at a time until that pin sets.
  • Decoder plate — the scale on top. The vertical lines are pin positions (1, 2, 3 …); the angled lines are depth readings. The pointer tells you which depth number that pin has.

2. The four steps

  1. Insert. Push the pick body fully into the keyway until it seats.
  2. Tension. Hold turning pressure on the tension lever, in the opening direction — just enough to keep it held.
  3. Lift. Use the lifter to raise each pin, one position at a time, until it sets. Work from the front of the lock to the back.
  4. Read. When all pins are set, the pointer on the decoder plate shows a depth number for each pin position. Note them down in order.

3. How much turning force is right?

This is where most beginners go wrong. The tension lever is not a lever to force open. It only keeps light rotational pressure on the plug, in the direction the lock opens.

  • The right amount depends on the lock. Some cylinders need slightly more, some barely any.
  • The rule is: not too much, not too little — just enough that the pins can still be lifted and set.
  • Start light and increase gradually if nothing sets.
  • Never use heavy force. If the turning pressure is too high, the pins bind against the plug, the lifter cannot raise them, and the tool can be damaged.

4. If pins will not set

  • Reduce tension. This is the cause in most cases.
  • Check insertion depth. The pick body must be fully seated.
  • Check the keyway. Confirm you have the right tool for this lock — use the tool finder or the compatibility chart.
  • Re-pick, do not force. Withdraw, reset, and start again with lighter pressure.

5. From reading to a working key

Depth numbers are not millimetres. Each model has its own depth values, listed in the technical manual. Convert the readings, cut the blank with the original Lishi cutter pliers, and test by hand before you leave the job.

Want to go deeper?

This guide covers the general principle only. Vehicle-specific techniques, decoding practice on real cylinders, key cutting and high-security locks are covered in our online training course, taught by practising locksmiths.

See the online training course →

Course places come with 20+ tools or the 32-piece set. If you already own your tools, you can still contact us about training access.

Related reading